Smart Guard
safety starts with driver update. that is the smartest guard. do you know how to update your drivers? if you don't we can help you. first visit our website. second find your driver by manufacturer or vendor. at last you download the driver by clicking on download driver button.



I want to use latest bios because it will be better 1. At first boot windows installed drivers for this card which I didn’t want to do. They might be similar enough you could replace one with the other, but they also might not be. Email will not be published required. Option ROM not enabled by setting df[6], so the disks are not bootable. The release notes hints at the existence of a newer 1. Welcome to Windows 7 Forums.

Uploader: Molabar
Date Added: 22 July 2006
File Size: 25.10 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 79583
Price: Free* [*Free Regsitration Required]

Those connected at boot were not detected. This is done the same way as with any other disk. All times are GMT The release notes hints at the existence of a newer 1.

Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. The original bytes were e8 xx xxwhere e8 is the opcode for the CALL instruction, and the bit immediate operand is the relative branch target. Find More Posts by Johng1. I also used pcicfg in DOS to check the card was detected.


I am replacing an Adaptec SA card.

jb36x Duufus, I had in the past this card: At this point in the code, register cl should contain the byte read from PCI configuration register 0xdf. Windows 7 Professional Trying to do that in the option ROM causes a several-minute hang during boot when loading the option ROM again, seemingly waiting for a disk pataa giving upeven when a PATA disk is present.

They might be similar enough you could replace one with the other, but they also might not be. Could you pass on a link please of your setup? I am having a hard time installing the drivers. You can download 1. This changes mov cl, 0x02 to mov cl, 0x There were problems with OSX with the first patch which is why eata second one exists.

JMicron┬« JMB PATA and SATA controller – Windows 7 Help Forums

It is jmicgon a data table containing some form of initial register values. Given my limited abilities to understand hex, I cannot locate where to apply the changes to.


Why do you want to avoid the on-board SATA controller? Final configuration PATA not enabled because turning it on causes a hang during boot. I can’t find which driver is related to the jmicron. When running XP, xontroller is well.

JMicron JMB363 Add-on Card AHCI mode

If so, I would start with the first patched ROM the one that sets df[1: What am I missing? A JMicron-specific driver is available only for Windows.

Can we get an update for firmware v1. Wata df[6] is used by the option ROM code at offset 0x They seem important, causing PCI config register bits 0xed[5: The time now is I even tried running under admin dirrectly but no difference. Email will not be published required.

Unfortunately, I do not know enough about hex editing to find where to patch.