Mode Quickly switching wireless configuration to be either [Station] or [Access Point]. Fundamental security setting is included. Anyone could join this access point and connect to internet. Channel Select the wireless channel within current channel plan. It always is RealTek. And you could pick one of these network connections.
|Date Added:||9 December 2006|
|File Size:||6.30 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This access point is without authentication protection with user.
Mapping of country and channel plan With check mark in front will make the status bar showing up. And then a Zero Config dialog is shown up to inform you. In this dialog, you could configure network name, applied channel, authentication and encryption rule on this Ad-Hoc node. Differential phase shift keying modulation schemes, DBPSK and DQPSK with data scrambling capability, are available, along with complementary code keying to provide data rates of 1, 2, 5.
No part of this document may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language in any form or by any means without the written permission of AzureWave Technologies, Inc. You could wake up a system through network packets. When in ad hoc aq, the Anyone could join this access point and connect to internet.
Next Go to next step, Finish, while the internet connection is selected. Infrastructure Configure the wireless as infrastructure type network. The access point is set as an opened hot-spot.
The final end product must be labeled in a visible area with the following: The detail contents are described in following wireless configuration sections for both Station and AP mode. However, there is no guarantee that interference will not occur in a particular installation. Connect the antenna twist-on connector bt235 to the wireless LAN antenna port male Place the antenna at an elevated location to enhance your wireless LAN valid coverage.
It is easy use to switch property pages just by left button clicking of mouse the title br253 each page The following six sections describes detail information of the opposite page.
Set Default Set the selected profile as default selection. Your system can not connect internet with this field empty.
Pool signal quality results more worst data throughput on high fragment threshold. The following setting should match the configuration of access point you join. The contents of properties area are dependant on wireless configuration that the selected adapter was set up. Your system should satisfy the following two requirements to apply this mode: The detail steps you should follow are described in section 4.
Locate the wireless LAN antenna port on the motherboard rear panel.
IP address of connecting access point Up Time: And you could pick one of these network connections. The length of SSID should be shorter than 32 characters. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Longer interval may increase the competition of wireless bt523. It provides a statistic analysis of packet transition. SSID list box Four fields are shown in the list box to provide access point status.
Add Add a new access point profile by manual input. While the radio being off, the links with other wireless network nodes are disconnected.